Start Program - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM

3.5 Start Program

Upon power-up, the DAq automatically starts Windows
and loads the Vertex M program. After the two-to-three
minute startup sequence, the Vertex M main screen
opens.
Note:
Any time the Vertex M System is powered up, loss
of communications may cause maintenance faults.
See Section 4.5.4 Event List
faults.
Note:
Use the Windows Date/Time Properties dialog box
to change the time zone, time and date on your
Vertex M System. Stop project if adjusting time and
time zone. Once complete restart project. See
tion 4.4.5 Stopping Project
CAUTION
Do not change language in Windows setup.
Section 3 - Startup
for instructions to clear
Sec-
on how to stop the project.
3-4