Printer; External Network Connection - Honeywell Vertex M Technical Handbook

Vertex M 24-Point Continuous Monitor
TM
The on-screen keyboard operates similar to a standard
keyboard except when using modifier keys (CTRL, ALT,
or SHIFT).
To use modifier keys:
1. Touch the modifier key. The key changes to
show the modifier key is locked down.
2. Press the second key of the key combination.
Figure 2-4. On-screen Keyboard

2.7.1 Printer

The Vertex M System software can be programmed
to print to either a network or local printer. To install a
local printer, connect it to the parallel printer port as
shown. You may also use the USB port. The correct
printer driver must also be installed.
Parallel Printer Port
Figure 2-5. Printer Connection
Section 2 - Installation
USB Port

2.7.2 External Network Connection

The Vertex M System can be connected to an external
Ethernet network at the port shown.
External Ethernet Connection
CAUTION
Do not connect an external network to the
Vertex M Ethernet hub. Use only the external
Ethernet connection (as shown in Figure 2-6)
on the back of the data acquisition computer.
Connecting an external network to the hub
will impair monitoring capability.
Figure 2-7. Ethernet cable
1. When using an Ethernet output, the conduit
must be connected to Earth ground.
2. The Vertex M comes with a Ferrite. Four wraps
of the Ethernet cable is needed as close to the
Vertex M as possible.
2-7
Figure 2-6.