Table of Contents
Advertisement
Vertex M
24-Point Continuous Monitor
TM
A.9 Modbus Plus Interface (P/N 1295-
0330)
For more information on Modbus Plus, see
eclipse.modicon.com. Technical information on the
ProSoft Technology MVI46-MBP interface which is
used in the Vertex M can be found at
technology.com.
The address of the Modbus Plus interface are set using
the configuration profile utility as described in See
Section 3.6 Configuration
are from 1 to 64.
The ProSoft website contains the MVI46s-MBP User
Manual. Of particular interest in this manual are the
general specifications on page 9 (in the pdf document)
and the status LED interpretations on page 58 (in the
pdf document).
Always wait for 20 seconds after energizing the PLC
or changing the address before evaluating the LEDs.
The data map used by the Modbus Plus interface is
shown in
Table
A-5. The interpretation of the data is in
Table A-3
and
Table
A-4.
Appendix A - Network Interface and Options
http://www.prosoft-
Utility. Valid address values
A.10 LonWorks Interface (P/N 1295-
0329)
http://
The LonWorks protocol per mits peer-to-peer
communication without relying on a central controller.
Routers permit expansion of networks to include
thousands of nodes. For more information about
LonWorks see
engenuity.com.
The LonWorks interface is implemented using a
FieldServer Technologies model FS-B2011 bridge and
other components. This is a purple box mounted below
the PLC in the rear of the Vertex M rack. The interface
can be operated in either Polled Mode or Bind Mode.
A service pin is provided for node identification. LED
indicators are provided for Power, Run, System Error,
and Configuration Error. Media type is FTT-10 twisted
pair. Information on the FS-B2011 may be obtained
from
http://www.fieldserver.com.
The LonWorks external interface has 154 network
variable outputs as listed in
of the data is in
F-16
http://www.echelon.com
Table
A-8. The interpretation
Table A-3
and
Table
A-4.
or
www.
Advertisement
Chapters
Table of Contents
