Figure 5-9: Location Of Rf-Connector At Bottom Of Sensor Housing - Honeywell SLG 700 User Manual

Ensure the small RF connector is seated firmly in place, on the bottom of the sensor
21.
electronics housing. See Figure

Figure 5-9: Location of RF-connector at bottom of sensor housing

If necessary, replace the o-ring at the top of the process connector. Apply o-ring
22.
Lubricant and carefully replace the Sensor electronics housing without pinching the
o-ring. Tighten the set screws.
Turn ON transmitter power.
23.
 If the COMM Firmware version is 1.020000 the transmitter should power up
and operate with no further configuration required. However, if a warning
message is displayed, it may be necessary to identify if a new sensor electronics
housing is being installed, or a new COMM module is being installed.
 If the COMM Firmware version is 1.010000, the model key information will not
be visible unless the information was programmed at factory. This does not
affect the operation of the transmitter.
If upgrading transmitter from sensor firmware version 1.000x00, the transmitter
24.
configuration will need to be set. However, if a new COMM module was ordered at
the same time as the sensor electronics a basic configuration will be already in place.
See manuals:
Publication #
34-SL-25-11
34-SL-25-06
34-SL-25-07
Note: The transmitter stores it's configuration on the COMM PCBA. Therefore you do not
need to transfer the configuration.
Page 124
5-9.
Publication Title
SLG 700 SmartLine Guided Wave Radar User's Manual
SLG 700 SmartLine Level Transmitter Guided Wave Radar
HART© Option User's Manual
SLG 700 SmartLine Level Transmitter Guided Wave Radar
FOUNDATION Fieldbus Option Manual
SLG 700 SmartLine Level Transmitter User's Manual
RF
Connector
Revision 7