Figure 5-5: Location Of Sensor Housing And Attachment Set Screws - Honeywell SLG 700 User Manual

2. Remove power from transmitter.
3. If a new terminal assembly is also being installed follow instructions 34-ST-33-64.
The relevant part numbers are listed in Table
GWR Level Terminator Module w/Lightning Protection Kit
for HART Modules
GWR Level Terminator Module w/Lightning Protection Kit
for FF Modules
GWR Level Terminator Module w/o Lightning Protection Kit
for HART Modules,
GWR Level Terminator Module w/o Lightning Protection Kit
for FF Modules
4. If a new Communications Module is also being installed follow instructions 34-ST-33-69.
5. Separate the sensor housing from the process connector by first loosening the 4 mm setscrews
(3) and gently separating the sensor electronics housing. Do not discard setscrews or o-rings.

Figure 5-5: Location of sensor housing and attachment set screws

Page 120
SLG 700 SmartLine Level Transmitter User's Manual
7-1.
50095191-502
50095191-510
50095191-501
50095191-509
Revision 7