Honeywell SLG 700 User Manual page 112

Reflectn Ref Loc (R)
ModelNumMismatch
(R)
Sensr DB Corrupt (R)
Reset Sensr DB (R)
(Sensor DB corrupt
only)
Comm DB Corrupt (R)
Reset Comm DB (R)
(Comm DB corrupt
only)
<Return>
Active Diags (R)
Supply Voltage (R)
Elec Module Temp (R)
DAC Temp Comp (R)
(HART only)
Sensor Comm (R)
Non-Crit Diag
Display Setup (R)
(HART only)
Characterized (R)
Charact. Status(R)
PV Range (R)
Sensor Over Temp (R)
Page 100
OK
FAULT
Yes
No
Yes
No
Yes
No
# #
OK
LOW
HIGH
OK
OVERTEMP
OK
NO
COMPENSA
TION
OK
SUSPECT
OK
NVM Corrupt
Yes
No
OK
FAULT
OK
Out Of
Range
OK
OVER TEMP
SLG 700 SmartLine Level Transmitter User's Manual
FAULT: Reflection reference cannot be located
Yes: Mismatch between Sensor and Comm
Module Model Numbers
Yes: The Sensor Module database is corrupt
and requires reset
Perform reset of Sensor Moduel database to
SLG720 factory defaults
Yes: The Comm Module database is corrupt
and requires reset
Perform reset of Comm Module database to
SLG720 factory defaults
Shows the number of Non-Critical Diagnostics
that are currently active
LOW: Supply voltage is below the low
specification limit
HIGH: Supply voltage is above the high
specification limit.
OVERTEMP: Electronics temperature is outside
the operating range (-40°C to +85°C).
The DAC has not been compensated for
temperature effects. This is a factory operation.
SUSPECT: The interface between the
Temperature Sensor Module and the Electronics
Module is experiencing intermittent
communication failures.
NVM Corrupt: The Display memory is corrupt.
Yes: Sensor is Characterized
No: Sensor is not Characterized
OK: Characterization table CRC is OK
FAULT: Sensor Characterization data is
corrupted.
When this fault occurred, Sensor Module fault of
Critical Diagnostic will be set.
Out of Range: PV is not within the range limits
OVERTEMP: Sensor temperature is greater
than 125°C.
Revision 7