Honeywell SLG 700 User Manual page 105

<Return>
Measured Prod
PV
SV
TV
Dynm
Variables
QV
(HART only)
<Return>
LRV
URV
Damping
NAMUR Output
Loop Curr Mode
4-20 mA
Output (HART
only)
Latching Mode
BDH/BDL Loop
<Return>
Set LRV
Set LRV
(HART only)
Set URV
Revision 7
Single Liquid
2 Liq Flooded
2 Liq NonFlood
Product Level
% Prod Level
Dist To Prod
Prod Lvl Rate
Product Volume
Vapor Thick
% Vapor Thick
Vapor Volume
Intf Level
% Intf Level
Dist To Intf
Intf Lvl Rate
Upr Prod Thick
Lower Prod Vol
Upper Prod Vol
#####.###
##.#
Disabled
Enabled
Latching
Non-Latching
Hi Saturation
Low Saturation
Last Good Val
Default
ATTENTION: Executing this service will set the
Lower Range Value (LRV) equal to the input
Guided Wave Radar Level.
ATTENTION: Executing this service will set the
Upper Range Value (URV) equal to the input
Guided Wave Radar Level.
SLG 700 SmartLine Level Transmitter User's Manual
Read-Only
PV = Primary Variable
SV = Secondary Variable
TV = Tertiary Variable
QV = Quaternary Variable
Configure the dynamic
variables for monitoring on
a host such as DTM or
handheld device.
Disabled: Sets loop output
and burnout levels to
Honeywell levels.
Enabled: Sets loop output
and burnout levels to the
NAMUR levels
Disabled: Required for
multi-drop HART
communications.
Latching Mode: This
parameter allows selection
of transmitter critical error
behavior.
Latching: The transmitter
will remain in a critical error
state until a user performs a
hardware / software reset.
Non-Latching: The
transmitter exits critical
error state automatically
when causes of the critical
error have been resolved.
Loop output when level is in
a high or low blocking
distance zone.
Press  to
enter menu
selection, 
and  to
select from
list,  to
enter
Press  to
enter menu
selection, 
and  to
select from
list,  to
enter and
shift to next
digit
Press  to
enter menu
selection, 
to execute
Page 93