Ipv6 Lisp Etr Map-Cache-Ttl - Cisco Nexus 7000 Series Command Reference Manual

ipv6 lisp etr map-cache-ttl

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
ipv6 lisp etr map-cache-ttl
To configure the Time-to-live (TTL) value inserted into Locator/ID Separation Protocol (LISP) IPv6
Map-Reply messages, use the ipv6 lisp etr map-cache-ttl command. To remove the configured TTL
value and return to the default value, use the no form of this command.
Syntax Description
time-to-live
1440
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ipv6 lisp etr map-cache-ttl command to change the default value associated with the TTL field
Usage Guidelines
in IPv4 Map-Reply messages. Use this command when you want to change the default TTL that remote
ITRs cache and use for your site's IPv4 EID prefix. The default value is 1440 minutes (24 hours), the
minimum value cannot be less than 60 minutes, and the maximum cannot be greater than 10080 minutes
(one week).
This command does not require a license.
This example shows how to configure the ETR to use a TTL in its IPv6 Map-Reply messages:
Examples
switch# configure terminal
switch(config)# ipv6 lisp etr map-cache-ttl 120
Related Commands Command
ipv6 lisp etr
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-88
ipv6 lisp etr map-cache-ttl time-to-live
no ipv6 lisp etr map-cache-ttl time-to-live
Value, in minutes, to be inserted in the TTL field in Map-Reply messages. The
range is from 60 to 10080.
Modification
This command was introduced.
Description
Configures the Cisco NX-OS device to act as an IPv6 LISP Egress Tunnel
Router (ETR).
Cisco Nexus 7000 Series LISP Commands