Ip Lisp Itr-Etr - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ip lisp itr-etr

To configure a Cisco NX-OS device to act as both an IPv4 LISP Ingress Tunnel Router (ITR) and Egress
Tunnel Router (ETR), use the ip lisp itr-etr command. To remove the LISP ITR functionality, use the
no form of this command.
This command has no arguments or keywords
Syntax Description
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ip lisp itr-etr command to enable the Cisco NX-OS device to perform both IPv4 LISP Ingress
Usage Guidelines
Tunnel Router (ITR) and Egress Tunnel Router (ETR) functionality simultaneously, by using a single
command.
For usage guidelines for the IPv4 LISP ITR functionality, see the ip lisp itr command.
For usage guidelines for the IPv4 LISP ETR functionality, see the ip lisp etr command.
If you use the ip lisp itr-etr command and either of the ip lisp itr or ip lisp etr command have already
Note
been configured, they will be automatically removed from the configuration file. When configuring a
device as both an ITR and an ETR, use the command ip lisp itr-etr to enable both capabilities.
This command does not require a license.
This example shows how to configure the IPv4 LISP ITR and ETR functionality:
Examples
switch# configure terminal
switch(config)# ip lisp itr-etr
OL-25345-01
ip lisp itr-etr
no ip lisp itr-etr
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ip lisp itr-etr
LSP-47