Ip Lisp Locator-Vrf - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ip lisp locator-vrf

To configure a nondefault virtual routing and forwarding (VRF) table to be referenced by any IPv4
locators, use the ip lisp locator-vrf command. To return to using the default routing table for locator
address references, use the no form of this command.
Syntax Description
vrf-name
default
IPv4 locator addresses are associated with the default (global) routing table.
Defaults
VRF configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(3)
When you configure Locator/ID Separation Protocol (LISP) in a nondefault VRF to keep EID-prefixes
Usage Guidelines
in one VRF separate from EID-prefixes in another VRF, and both EID VRFs share the same
locator-based core network and same mapping database system infrastructure, these locator addresses
must be reachable from the default VRF or a specified common VRF. Use the ip lisp locator-vrf
command to specify the VRF to be associated with these locator addresses.
When you enter the ip lisp locator-vrf command, the locator addresses in any subsequent LISP
commands are referenced to the specified VRF. For example, the locator addresses in the ip lisp itr
map-resolver and ip lisp etr map-server commands refer to the VRF that you configured when you
entered the ip lisp locator-vrf command. The map-servers and map-resolvers can also share the
configuration from the locator-VRF.
When you configure mixed address families (for example, IPv4 EIDs and IPv6 locators or IPv6 EIDs
Note
and IPv4 locators), use the ip lisp locator-vrf command.
This command does not require a license.
OL-25345-01
ip lisp locator-vrf {vrf-name| default}
no ip lisp locator-vrf {vrf-name| default}
Name of the VRF instance to be referenced by IPv4 locator addresses.
Specifies that the default VRF should be referenced by the IPv4 locator
addresses.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ip lisp locator-vrf
LSP-51