Cisco Nexus 7000 Series Command Reference Manual page 106

ipv6 lisp itr map-resolver
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
This example shows how to configure an ITR to use the Map-Resolver located at 2001:DB8:0A::1 when
Examples
sending its Map-Request messages.
switch# configuration terminal
switch(config)# ipv6 lisp itr map-resolver 2001:DB8:0A::1
Related Commands Command
ipv6 lisp alt-vrf
ipv6 lisp itr
ipv6 lisp
map-request-source
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-96
Description
Configures the VRF that LISP should use when sending Map Requests for
an IPv6 EID-to-RLOC mapping directly over the ALT.
Configures the switch to act as an IPv6 LISP Ingress Tunnel Router (ITR).
Configures the source IPv4 or IPv6 address to be used in IPv6 LISP
Map-Request messages.
Cisco Nexus 7000 Series LISP Commands