Ipv6 Lisp Itr-Etr - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ipv6 lisp itr-etr

To configure a switch to act as both an IPv6 LISP Ingress Tunnel Router (ITR) and Egress Tunnel Router
(ETR), use the ipv6 lisp itr-etr command. To remove the LISP ITR functionality, use the no form of this
command.
This command has no arguments or keywords.
Syntax Description
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ipv6 lisp itr-etr command to enable the Cisco NX-OS device to perform both IPv6 LISP Ingress
Usage Guidelines
Tunnel Router (ITR) and Egress Tunnel Router (ETR) functionality simultaneously, by using a single
command.
For usage guidelines for the IPv6 LISP ITR functionality, see the ipv6 lisp itr command.
For usage guidelines for the IPv6 LISP ETR functionality, see the ipv6 lisp etr command.
If you use the ipv6 lisp itr-etr command and either of the ipv6 lisp itr or ipv6 lisp etr command have
Note
already been configured, they will be automatically removed from the configuration file. When
configuring a device as both an ITR and an ETR, use the command iv6p lisp itr-etr to enable both
capabilities.
This command does not require a license.
This example shows how to configure the IPv6 LISP ITR and ETR functionality on the NX-OS device:
Examples
switch# configuration terminal
switch(config)# ipv6 lisp itr-etr
OL-25345-01
ipv6 lisp itr-etr
no ipv6 lisp itr-etr
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ipv6 lisp itr-etr
LSP-99