Cisco Nexus 7000 Series Command Reference Manual page 37

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
When you use the ip lisp alt-vrf command, the referenced VRF must already have been created by using
Note
the vrf context command. In addition, the corresponding configurations for connecting the LISP device
to the ALT, including the generic routing encapsulation (GRE) tunnel interface(s) and any routing that
is associated with the VRF (static or dynamic) you must also have created.
This example shows how to configure the VRF named lisp and then configure LISP to use this VRF
Examples
when resolving IPv4 EID-to-RLOC mappings:
switch# configure terminal
switch(config)# vrf context lisp
switch(config-vrf)# exit
switch(config-vrf)# ip lisp alt-vrf lisp
Related Commands Command
ip lisp itr map-resolver Configures the IPv4 or IPv6 locator address of the LISP Map-Resolver to
ip lisp it
ip lisp proxy-itr
OL-25345-01
virtualized LISP deployment, you must configure the PITR to use a Map-Resolver for
EID-to-RLOC mapping resolution, not the LISP ALT because the LISP ALT does not support
virtualization.
Description
which the ITR sends IPv4 Map-Request messages.
Configures the Cisco NX-OS device to act as an IPv4 LISP Ingress Tunnel
Router (ITR).
Configures the NX-OS device to act as an IPv4 LISP Proxy Ingress Tunnel
Router (PITR).
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ip lisp alt-vrf
LSP-27