Pv6 Lisp Proxy-Itr - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

pv6 lisp proxy-itr

To configure a switch to act as an IPv6 Locator/ID Separation Protocol (LISP) Proxy Ingress Tunnel
Router (PITR), use the ipv6 lisp proxy-itr command. To remove the LISP PITR functionality, use the
no form of this command.
Syntax Description ipv6-local-locator
ipv4-local-locator
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ipv6 lisp proxy-itr command to enable IPv4 LISP Proxy Ingress Tunnel Router (PITR)
Usage Guidelines
functionality on the Cisco NX-OS device. The Cisco NX-OS device receives native packets from
non-LISP sites that are destined for LISP sites, encapsulates them, and forwards them to the ETR that is
authoritative for the destination LISP site EID.
PITR services are required to provide interworking between non-LISP sites and LISP sites. For example,
when connected to the Internet, a PITR acts as a gateway between the legacy Internet and the
LISP-enabled network. The PITR must advertise one or more highly aggregated endpoint identifier
(EID) prefixes on behalf of LISP sites into the underlying DFZ (that is the Internet) and act as an ITR
for traffic received from the public Internet.
When you enable PITR services by using the ipv6 lisp proxy-itr command, the PITR creates
LISP-encapsulated packets when it sends a data packet to a LISP site, sends a data probe, or sends a
Map-Request message. The outer (LISP) header address family and source address are determined as
follows:
OL-25345-01
ipv6 lisp proxy-itr ipv6-local-locator [ipv4-local-locator]
no ipv6 lisp proxy-itr ipv6-local-locator [ipv4-local-locator]
IPv6 locator address used as a source address for encapsulation of data packets,
a data probe, or a Map-Request message.
(Optional) IPv4 locator address used as a source address for encapsulation of
data packets, a data probe, or a Map-Request message when the locator-hash
function returns a destination Routing Locator (RLOC) in the IPv4
address-family.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
pv6 lisp proxy-itr
LSP-119