Ip Lisp Etr Map-Cache-Ttl - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ip lisp etr map-cache-ttl

To configure the Time-to-live (TTL) value inserted into Locator/ID Separation Protocol (LISP) IPv4
Map-Reply messages, use the ip lisp etr map-cache-ttl command. To remove the configured TTL value
and return to the default value, use the no form of this command.
Syntax Description
time-to-live
1440
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ip lisp etr map-cache-ttl command to change the default value associated with the TTL field
Usage Guidelines
in IPv4 Map-Reply messages. Use this command when you want to change the default TTL that remote
ITRs cache and use for your site's IPv4 EID prefix. The default value is 1440 minutes (24 hours), the
minimum value cannot be less than 60 minutes, and the maximum cannot be greater than 10080 minutes
(one week).
This command does not require a license.
This example shows how to configure the ETR to use a TTL of 120 minutes in its IPv4 Map-Reply
Examples
messages:
switch# configure terminal
switch(config)# ip lisp etr map-cache-ttl 120
Related Commands Command
ip list etr
OL-25345-01
ip lisp etr map-cache-ttl time-to-live
no ip lisp etr map-cache-ttl time-to-live
Value, in minutes, to be inserted in the TTL field in Map-Reply messages. The
range is from 60 to 10080.
Modification
This command was introduced.
Description
Configures the Cisco NX-OS device to act as an IPv4 LISP Egress Tunnel
Router (ETR).
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ip lisp etr map-cache-ttl
LSP-37