Cisco Nexus 7000 Series Command Reference Manual page 159

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
You can configure multiple map-server commands so that registration can occur to different
Map-Servers with either the same or different authentication keys.
You should configure the home Map-Server, the one that the dynamic-EID initially registered to, as the
Note
dynamic-EID Map-Server.
If you do not enter the map-server dynamic-EID subcommand command, the configured map-server on
the LISP-VM router that was configured by using the {ip | ipv6} lisp etr map-server command is used
to register the dynamic-EID.
If you configure the proxy-reply option, the Map-Register sends Map-Server requests that the
Map-Server proxy map-reply on behalf of dynamic-EIDs when it receives a Map-Request for the
dynamic-EID prefix.
This command does not require a license.
The following example shows how to configure the LISP dynamic-EID policy named Roamer-1, enter
Examples
dynamic-EID configuration mode, and configure the Map-Server with IPv4 locator 10.1.1.1 for
dynamic-EIDs that match this policy to register to. The Map-Server is also specified to proxy-reply on
behalf of the dynamic-EID.
switch# configuration terminal
switch(config)# lisp dynamic-eid Roamer-1
switch(config-lisp-dynamic-eid)# map-server 10.1.1.1 key 3 1c27564ab1212434
switch(config-lisp-dynamic-eid)# map-server 10.1.1.1 proxy-reply
Related Commands Command
lisp site
lisp mobility
OL-25345-01
Description
Configures a LISP site and enters site configuration mode on a Map-Server.
Configures an interface on an ITR to participate in LISP VM mobility
(dynamic-EID roaming).
Cisco Nexus 7000 Series NX-OS LISP Command Reference
map-server
LSP-149