Cisco Nexus 7000 Series Command Reference Manual page 136

ipv6 lisp translate
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
This feature may be useful when if you want to upgrade but you want to continue to communicate with
non-LISP sites. An alternative approach for providing communications between LISP and non-LISP
sites is to use Proxy-ITR services. See to the ipv6 lisp proxy-itr command for further details. Both
proxy-ITR and NAT translation services, commonly referred to as Interworking services, are described
in draft-ietf-lisp-interworking-00.
This command does not require a license.
This example shows how to configure LISP to translate the inside address to the outside address:
Examples
switch# configuration terminal
switch(config)# ipv6 lisp translate inside 2001:db8:aa::1 outside 2001:db8:bb::1
Related Commands Command
ipv6 lisp etr
ipv6 lisp itr
ipv6 lisp proxy-itr
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-126
Description
Configures the switch to act as an IPv6 LISP Egress Tunnel Router (ETR).
Configures the switch to act as an IPv6 LISP Ingress Tunnel Router (ITR).
Configures the switch to act as an IPv6 LISP Proxy Ingress Tunnel Router
(PITR).
Cisco Nexus 7000 Series LISP Commands