Cisco Nexus 7000 Series Command Reference Manual page 145

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
ifconfig eth0 eid-address netmask 255.255.255.255
route add default any-switch-address
arp -s any-switch-address 00:00:0e:1d:01:0c
All LISP VM-router interfaces (the interface the dynamic-EID will roam to) must have the same MAC
address. You can configure interfaces by using the mac-address 0000.0e1d.010c command:
This feature is available for both IPv4 and IPv6. However, this feature is tested for IPv4 only. In addition,
Note
while necessary ARP changes have been made for IPv4, similar required changes for ND for IPv6 have
not been implemented.
This command does not require a license.
This example shows how to configure the LISP dynamic-EID policy named Roamer-1 and enter
Examples
dynamic-EID configuration mode:
switch# configuration terminal
switch(config)# lisp dynamic-eid Roamer-1
switch(config-lisp-dynamic-eid)#
Related Commands Command
lisp mobility
OL-25345-01
Description
Configures an interface on an ITR to participate in LISP VM-mobility
(dynamic-EID roaming).
Cisco Nexus 7000 Series NX-OS LISP Command Reference
lisp dynamic-eid
LSP-135