Honeywell DR4300 Product Manual page 96

DR4300 Circular Chart Recorder
Step Operation
4 Select other function
parameters
5 Change the value or
selection
Enter the value or selection
6
Exit Configuration
7
8 2-Pen Recorders
84
Press
FUNC
or
FUNC
or
SET
UP
DISP
FUNC
DR4300 Circular Chart Recorder Product Manual
Result
• Successive presses of the FUNC key will
sequentially display the other function prompts of the
set up group you have selected.
• Stop at the function prompt that you want to change,
then proceed to the next step.
• These keys increment or decrement the value or
selection that appears for the function prompt you
have selected.
Configuration Tips
• See Subsection 4.3.4
instructions to increase or decrease value quickly.
• Change the value or selection to meet your needs.
• If the display flashes, you are trying to make an
unacceptable entry.
• This key selects another function prompt.
• This key selects another set up group.
The value or selection you have made will be entered
into memory after another key is pressed.
This exits configuration mode and returns the recorder
to the same state it was in immediately before you
entered configuration mode. Any changes made during
the configuration session are stored when
configuration mode is exited.
For 2-pen recorders, press FUNC key to select INP 2
for display and return to step 1 to configure the
parameters for pen 2.
for
4/00