Auxiliary Output Set Up Group; Table 4-14 Auxiliary Output Parameter Definitions - Honeywell DR4300 Product Manual

4.3.16 Auxiliary Output Set Up Group

Introduction
The auxiliary output set up group lets you enable or disable the auxiliary output selection which provides a
milliampere output representing one of four control parameters: Input, Output, Setpoint, or Deviation. You
can also set the auxiliary output low and high scaling factors.
Auxiliary output group prompts
Table 4-14 lists all the function prompts in the auxiliary output set up group and their definitions.
For a 2-pen recorder, the desired input channel is displayed on the left side of the operator interface.
Press FUNC to select channel.
Press SETUP key until "AUX OUT" appears in the lower display.
Press FUNC key to select the parameters.
Lower Display
Prompt
AUXOUT
4/00

Table 4-14 Auxiliary Output Parameter Definitions

Upper Display
Range of Setting
or Selection
NONE [factory setting]
INP
OUT
SP
DR4300 Circular Chart Recorder Product Manual
Configuration, Startup, and Operation
Parameter
Definition
AUXILIARY OUTPUT SELECTION provides an mA
output representing any of four control parameters. The
display for Auxiliary Output viewing will be in engineering
units for all but output. Output will be designated in
percent (%).
The Auxiliary Output is the same output as the Current
Output and is not available if the control output algorithm
= CUR, CurT, or Tcur.
Other prompts affected by these selections: "4 mA VAL"
and "20mA VAL".
NO AUXILIARY OUTPUT
INPUT—This represents the configured range of input.
FOR EXAMPLE:
Type "J" Thermocouple (0 °F to 1600 °F)
0 °F display = 0 % output
1600 °F display = 100 % output
OUTPUT—Represents the displayed controller output in
percent (%).
SETPOINT—Represents the value of the setpoint in units
of PV.
of Recorder with Display
109