Honeywell DR4300 Product Manual page 236

DR4300 Circular Chart Recorder
Function
Putting the Program in
the Run State
Putting the Program in
the Hold State
External Hold
External Run
Viewing the Present
Ramp or Soak Segment
Number and Time
224
Press
DISPLAY
DISPLAY
DISPLAY
until you see
DR4300 Circular Chart Recorder Product Manual
Result
until
Lower Display
HOLD
to toggle from "HOLD" to
Lower Display
RUN
to indicate that the program is running.
until
Lower Display
RUN
to toggle from "RUN" to
Lower Display
HOLD
to hold the program at the current
setpoint.
If the recorder supports digital inputs, and REMSWn is
set to HOLD, then when the contact n closes, the
program will be placed in hold (if the setpoint program is
running).
The "hold" in the lower display will be displayed
periodically in lower case.
ATTENTION The keypad takes priority over the external
switch for the RUN/HOLD function.
Contact reopening runs the program.
If the recorder supports digital inputs, and REMSWn is
set to RUN, then when the contact n closes, the program
will be run (if the setpoint program is enabled).
The "run n" in the lower display will be displayed
periodically in lower case.
ATTENTION The keypad takes priority over the external
switch for the RUN/HOLD function.
Contact reopening holds the program.
Upper Display
input value
Lower Display
XX HH . MM
Time remaining in the SEGMENT in
hours and minutes
XX = 1 to 24
4/00