Advertisement
Quick Links
Document Number
Kit Contents
Summary
Chart hub types
44-45-33-60B
Models DR4200, DR4300, and
DR4500 Recorders
Replacement Instruction
Chart Hub Kit (30756150-501)
Form: 44-45-33-60B
Effective: 7/00
Supersedes: 3/99
This Chart Hub Replacement Kit contains the following parts:
Description
• Allen wrench 1, 5 mm
• Chart hub ass'y, tamper resist.
• Chart hub ass'y, large diam.
• Compression spring
• Chart hub ass'y, small diam.
Enclosed is a new chart hub kit with parts required to replace the chart
hub in a DR4200, DR4300, or DR4500 recorder. Use the following
procedures, as appropriate, to replace the existing chart hub assembly.
WARNING
Never access components inside the case, or remove or install
any connectors, with power applied.
Chart Hub Type
Hub used with ink pens and
preprinted charts when
approval bodies or process
inspectors require tamper
proof operation.
Standard hub used on all
DR4500/DR4300/DR4200
recorders.
Hub used with ink pens and
preprinted charts that have a
small center hole.
Quantity
1
1
1
1
1
Description
How to intall
Slide hub down to
bottom of motor shaft
and tighten set screw.
Push hub onto motor
shaft.
Push hub onto motor
shaft.
Page 1 of 4
Advertisement
Related Manuals for Honeywell DR4200
Summary of Contents for Honeywell DR4200
- Page 1 • Chart hub ass’y, small diam. Enclosed is a new chart hub kit with parts required to replace the chart Summary hub in a DR4200, DR4300, or DR4500 recorder. Use the following procedures, as appropriate, to replace the existing chart hub assembly. WARNING Never access components inside the case, or remove or install any connectors, with power applied.
- Page 2 Follow the procedure in Table 1 to replace the existing chart hub DR4200/DR4300 assembly in your recorder. Procedure Table 1 – Chart Hub Assembly Replacement for DR4200/DR4300 Recorders Step Action Open the chart door and swing the chart plate out. Remove chart hub (front of chart plate) and chart motor (rear of chart plate) by removing screws.
- Page 3 Kit Instruction, continued Refer to Figure 2 for the component locations and Table 2 for the Component Location installation procedure. for DR4500 Chart Spring 24241 Chart Motor Figure 2 – Component Location Follow the procedure in Table 2 to replace the existing chart hub in your DR4500 Procedure recorder.
- Page 4 However, we assume no responsibility for its use. While we provide application assistance personally, through our literature and the Honeywell web site, it is up to the customer to determine the suitability of the product in the application. Sensing and Control...