Lock Out Parameter Set Up Group; Table 4-18 Lockout Parameter Definitions - Honeywell DR4300 Product Manual

4.3.20 Lock Out Parameter Set Up Group

Introduction
This is the parameter used to lockout any unauthorized changes to the recorder's configuration, calibration,
and pen alignment parameters. Calibration group functions are described in Section 5 – Input and Output
Calibration for Recorder with Display. Pen alignment group functions are described in Section 8 –
Troubleshooting and Pen Alignment for Recorder with Display.
Set this group last
Because this group contains functions that have to do with security and lockout, we recommend that you
configure this group last, after all the other configuration data has been entered.
Lockout group prompts
Table 4-18 lists the function prompt in the lock out set up group.
Press SETUP key until "LOCK" appears in the lower display.
Press FUNC key to select the parameter.
Lower Display
Prompt
LOCK
ATTENTION
The Lock function cannot be changed when the RUN/SETUP switch is in the "SETUP" position, making it
usable as a physical lockout. Whatever lockout level is selected, it is protected as long as the switch is in
the SETUP position.
4/00

Table 4-18 Lockout Parameter Definitions

Upper Display
Range of Setting
or Selection
NONE [factory setting]
CAL
CONF
FULL
DR4300 Circular Chart Recorder Product Manual
Configuration, Startup, and Operation
Parameter
Definition
LOCK limits access to one or more types of set up
groups. Do not configure until all configuration is
complete.
NO LOCKOUT—All groups read/write.
CAL—Locks out calibration and pen alignment groups;
they will not even be displayed. All other groups are
available for read/write.
CONF—Tuning and cycle parameters are read/write. All
other configuration groups (except lock) are read only.
Calibration and pen alignment groups are not displayed.
FULL— All configuration groups (except lock) are read
only. Calibration and pen alignment groups are not
displayed.
of Recorder with Display
115