Input Parameters Set Up Group; Table 4-5 Input Parameter Definitions - Honeywell DR4300 Product Manual

Circular chart recorder
Hide thumbs Also See for DR4300:
Table of Contents

Advertisement

4.3.7 Input Parameters Set Up Group

Introduction
These are the parameters required to configure the temperature units, decimal location, actuation, high and
low range values in engineering units, bias, filter, and burnout. For a 2-pen recorder, the desired input
channel is displayed on the left side of the operator interface.
Press FUNC key to select channel.
Input group prompts
Table 4-5 lists all the function prompts in the input set up group.
Press SETUP key until "INPUT" appears in the lower display.
Press FUNC key to display the parameters.
Lower Display
Prompt
DECMAL
XXXX [factory setting]
XXX.X
XX.XX
UNITS
NONE
F
C
4/00

Table 4-5 Input Parameter Definitions

Upper Display
Range of Setting
or Selection
DECIMAL POINT LOCATION—This selection determines where
the decimal point appears in the display.
None
One Place
Two Places
NOTE: Be sure the selection agrees with the value to be displayed.
If PV requires 4 whole digits, the decimal will not show. Value of "IN
TYP" parameter must be for a linear input type for two decimal
places to be displayed.
TEMPERATURE UNITS—This selection will be indicated on the
PV display.
No units
[factory setting]
Degrees Fahrenheit
Degrees Celsius
DR4300 Circular Chart Recorder Product Manual
Configuration, Startup, and Operation
of Recorder with Display
Parameter
Definition
85

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dr4300 seriesDr4322Dr4321Dr4301Dr4302Dr4311 ... Show all

Table of Contents