Configuration Tips; Table 4-2 Configuration Tips - Honeywell DR4300 Product Manual

DR4300 Circular Chart Recorder

4.3.4 Configuration Tips

Introduction
Table 4-2 contains tips that will help you enter the configuration data more quickly. If you can not change
configuration parameters, check the status of the "LOCK" parameter (see Subsection 4.3.19).
Function
Displaying Groups
Displaying Functions
Scrolling
Changing values quickly
Exiting Set Up mode
Timing out from
Set Up mode
78

Table 4-2 Configuration Tips

Use the SET UP key to display the set up groups. The group titles are
listed in this section in the order that they appear in the recorder.
Use the FUNC key to display the individual function parameters under
each group. The prompts are listed in the order of their appearance in each
group.
Holding the SET UP key in will scroll through the set up groups. However,
when any set up group is displayed, you can scroll through the set up
groups twice as fast using the
the FUNC key in to scroll through the prompts within that group.
When changing the value of a parameter, you can adjust a more significant
digit in the upper display by holding in one key [ ] or [ ], and pressing the
other [ ] or [ ] at the same time.
• The adjustment will move one digit to the left.
• Press the key again and you will move one more digit to the left.
To exit Set Up mode, press the DISP key.
This returns the display to the same state it was in immediately preceding
entry into the Set Up mode.
If you are in Set Up (configuration) mode and do not press any keys for one
minute, the recorder will time out and revert to the mode and display that
was being used prior to entry into Set Up mode.
DR4300 Circular Chart Recorder Product Manual
Tip
or key. When in any set up group, hold
4/00