Honeywell DR4300 Product Manual page 139

Step
5 Enter the setpoint
Select automatic
6
mode
7 Start up Controller
#2
Exit Startup
8
4/00
Operation Press
DISP
until
or
MAN
AUTO
RESET
FUNC
DR4300 Circular Chart Recorder Product Manual
Configuration, Startup, and Operation
Action/Result
Upper Display
shows the input (PV) value.
Lower Display
SP and the setpoint value for
the selected channel.
Adjust the setpoint to the value at which you want the
process variable maintained.
Until "A" indicator is ON.
The recorder is in Automatic mode.
The recorder will automatically adjust the output to
maintain the process variable at setpoint as tracked by
the pen trace.
Until INP 2 indicator on left side of display is lit.
For recorders with two control outputs enabled, repeat
steps 2 to 6 for the second control output, but be sure
INP "2" indicator is lit instead of INP "1".
Close the door and monitor the operation.
of Recorder with Display
127