Grounding The Chassis - Cisco ASR 5000 Series Installation Manual

▀ Installing the Chassis
Step 5
Mount the chassis to the rails of the equipment rack with the hardware that was supplied with the equipment rack. Begin
with the two bottom holes and work your way up until all holes on each flange are secured.
Step 6 Repeat step 1 through step 5 for any additional chassis you are installing in the equipment rack.
Step 7 Proceed to the

Grounding the Chassis

Grounding the Chassis
Make sure that the chassis is properly grounded prior to installing any chassis sub-components or cards. The chassis and
the equipment rack or telecommunications cabinet that it is installed in must be connected to the same ground.
Caution:
its components.
There are two sets of grounding terminals located at the lower-rear of the chassis. The following figure and the table that
follows show the location of these terminals and provide specifications for the appropriate lug and cable size.
▄ ASR 5000 Installation Guide
76
section and ground the chassis.
Failure to properly ground the chassis could result in personal injury and/or damage to the chassis and
Chassis Installation