Cisco ASR 5000 Series Installation Manual page 202

▀ Adding Half-Height Line Cards
Step 9
Repeat step 1 through step 7 for every other line card that to be installed.
Step 10
Install blanking panels over any unused chassis slots.
W
ARNING
cover any chassis slot that is not occupied by an application card. Leere Steckplaetze muessen mit der dafuer
vorgesehenen Abdeckplatte geschlossen werden, um die Luftzirkulation innerhalb des Geraets zu gewaehrleisten und um
einen elektrischen Schlag zu vermeiden.
Step a
Step b
secure the panel to the chassis.
Step 11
Refer to one of the following chapters in this guide for information on cabling the line cards you just installed.
Line Card
Switch Processor Input/Output (SPIO)
Fast Ethernet Line Card (FLC2)
Gigabit Ethernet Line Card (GLC2)
Quad Gigabit Ethernet Line Card (QGLC)
10 Gigabit Ethernet Line Card (XGLC)
Optical (ATM) (OLC2)
Channelized Line Card Interfaces (CLC2)
▄ ASR 5000 Installation Guide
202
:
To reduce the risk of electric shock and to ensure proper ventilation, blanking panels must be used to
Position the blanking panel over the unused chassis slot(s).
Use a Phillips #2 screwdriver to tighten the screws at the top and bottom of the blanking panel to
Adding Application and Line Cards to an Existing Installation
Chapter
Cabling the Switch Processor Input/Output Line Card
Cabling the Ethernet 10/100 Line Card
Cabling the Gigabit Ethernet Line Cards
Cabling the Optical (ATM) Line Card
Cabling the Channelized Line Card