Connecting To The Console Port - Cisco ASR 5000 Series Installation Manual

▀ Connecting to the Serial Console Port
This adapter provides a serial port on a laptop or workstation that does not have one. It draws power from the USB port.
Figure 35.

Connecting to the Console Port

Important:
DB-9 serial (EIA-232) adapter shipped with the SPIO to connect to the Console port. Use these components to connect
to a workstation running a communications application that can access the workstation's serial port, such as Minicom
for Linux® or HyperTerminal® for Windows.
To connect to the Console port, follow the instructions below.
Step 1
Connect the RJ-45 end of the cable to the port labeled Console on the SPIO.
Step 2
Connect one end of the RJ-45-to-RJ-45 cable into the DB-9 adapter.
Step 3
Connect the DB-9S (female) end of the cable assembly to the DB-9P (male) serial port on the workstation.
Step 4 Configure the communications application on the workstation to support the following settings: 115200 bps, 8 data bits,
no parity, 1 stop bit, no flow control.
▄ ASR 5000 Installation Guide
116
USB to Console Port Interconnection
The following instructions assume that you are using the RJ-45-to-RJ-45 cable with the RJ-45-to-
Cabling the Switch Processor Input/Output Line Card