▀ Removing the Line Card
Removing the Line Card
This section describes how to remove a line card.
Important:
Guide for instructions on how to switch services to a redundant (standby) card.
Step 1
Detach any cables that are attached to the line card. The end of each cable should be labelled with its destination.
Replace any missing labels prior to removal.
Step 2
Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the line card's front panel.
Step 3
Slide the interlock switch on the front panel of the line card downward.
Caution:
To minimize the risk of data loss, ensure that all LEDs on the line card are Off (extinguished) prior to removing the
card from the chassis.
Step 4
Pull the ejector levers outward, firmly and straight, until the card is unseated from the chassis.
▄ ASR 5000 Installation Guide
252
Before removing and replacing a line card on an active system, refer to the System Administration
To avoid damaging the card's interlock switch, ensure that it is completely down before proceeding.
Replacing Line Cards