Cisco ASR 5000 Series Installation Manual page 131

Cabling the Gigabit Ethernet Line Cards
Table 41. SFP Modules Supported by the QGLC
Module Type Card Identification
1000Base-SX Ethernet 1000 SX
1000Base-LX Ethernet 1000 LX
1000Base-T Ethernet 1000 Copper
Important:
use with the QGLC.
Important:
for Class 1 laser devices for IEC825, EN60825, and 21CFR1040 specifications.
Interface Type
Fiber, LC duplex
female connector
Fiber, LC duplex
female connector
RJ-45
The SFP interface is only certified to work with SFP transceiver modules purchased from Cisco for
Because of the optical SFP interface, this product has been tested and found to comply with the limits
Cable Specifications
Fiber Type: Multi-mode fiber (MMF), 850 nm wavelength
Core Size (microns)/Range:

62.5/902.23 feet (275 meters)

50/1640.42 feet (500 meters)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -17 dBm
Fiber Type: Single-mode fiber (SMF), 1310 nm wavelength
Core Size (microns)/Range: 9/32808.4 feet (10 Kilometers)
Minimum Tx Power: -9.5 dBm
Rx Sensitivity: -19 dBm
Operates in full-duplex up to 100 meters of CAT-5 shielded
twisted pair (STP) cable with BER less than 10e-10.
NOTE: To comply with GR-1089 intra-building, lightning-
immunity requirements and ensure compliance with Radiated
Emissions Criteria, you must use shielded-twisted pair cable
and ensure that it is properly terminated at both ends.
Quad Gigabit Ethernet Line Card (QGLC) ▀
ASR 5000 Installation Guide ▄
131