Spio Run/Fail Led States - Cisco ASR 5000 Series Installation Manual

▀ Verifying the Installation
Figure 54.

SPIO Run/Fail LED States

The SPIO's Run/ Fail LED indicates the overall status of the card. This LED is illuminated steady green for normal
operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 59. SPIO Run/Fail LED States
Color Description
Green Card powered with no
errors detected
Red Card powered with
error(s) detected
None Card is not receiving
power
▄ ASR 5000 Installation Guide
168
SPIO LEDs
Troubleshooting
None needed.
Errors were detected during the POSTs. It is likely that the errors were logged to the
system's command line interface during the boot process.
Refer to the System Administration Guide for troubleshooting information.
Verify that the POWER LEDs on the PFUs are green. If they are not, refer to
the LED on the PFU
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in this document.
If all of the above suggestions have been verified, it is possible that the SPIO is not
functional. Please contact your service representative.
for troubleshooting information.
Applying Power and Verifying the Installation
Checking