Installing Half-Height Line Cards - Cisco ASR 5000 Series Installation Manual

▀ Installing Half-Height Line Cards

Installing Half-Height Line Cards
This section provides instructions for adding half-height line cards to the chassis.
Caution:
to the components. Failure to do so could result in damage to sensitive electronic components and potentially void your
warranty.
Important:
Step 1
Determine the type of line card you are installing. Each line card is identified by the text near the bottom of its front
panel.
Step 2 Determine which chassis slot to install the card in based on the information in
Assignments.
Step 3
Remove the blanking panel covering the slot, if one is installed.
Step a
Step b
the chassis slot.
Step 4 Slide the interlock fully downward on the card. Flip the ejector levers outward and away from the face plate.
▄ ASR 5000 Installation Guide
98
During installation, maintenance, and/or removal, wear a grounding wrist strap to avoid ESD damage
The XGLC is a full-height line card that takes up the upper and lower slots in the back of the chassis.
Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the blanking panel.
Hold the screws on the blanking panel, and pull the blanking panel away from the chassis to expose
Line Card Installation
Chassis Slot Numbering and