Interface Specifications - Cisco ASR 5000 Series Installation Manual

Technical Specifications

Interface Specifications

The table below lists the line card interfaces for use within the chassis.
Table 88. Line Card Interfaces
Card Type Port
SPIO Console
Console Cable Assembly
Gigabit Ethernet
10/100 Mbps
CO Alarm
CO Alarm cable Assembly
BITS BNC (optional)
BITS 3-Pin (optional)
10/100 Ethernet
FLC2
Gigabit Ethernet
GLC2
QGLC Gigabit Ethernet
XGLC 10 Gigabit Ethernet
OLC2 ATM/POS OC-3 SM IR-1
ATM/POS OC-3 Multi-Mode
Channelized (STM-1/OC-3) SM IR-1
CLC2
Channelized (STM-1/OC-3)Multi-Mode
Notes
1. An RJ-45 Ethernet interface may have more than one pin-out configuration, depending on the type of cable used.
2. An SPIO may be equipped with one type of BITS connector – BNC or 3-pin.
3. A Small Form-factor Pluggable transceiver is supplied with the GLC2 based on the customer-specified interface
type.
4. Four Small Form-factor Pluggable transceivers are supplied with the QGLC based on the customer-specified
interface type.
5. An enhanced SFP (SFP+) transceiver is supplied with the XGLC based on the customer-specified interface type.
Quantity Connector Type
1 RJ-45, RS-232 serial
1 RJ-45 to DB-9
2 Optical SFP
2 RJ-45, Ethernet
1 10-pin, Molex
1 Dual 10-pin Molex to barrier terminal
1 BNC, coaxial cable
3-pin, wire-wrap
8 RJ-45, Ethernet
1 SFP-SX
SFP-LX
SFP-T, copper RJ-45
4 SFP-SX
SFP-LX
SFP-T, copper RJ-45
1 10GBase-SR, SFP+
10GBase-LR, SFP+
1 Single-mode Fiber, LC duplex
Multi-mode Fiber, LC duplex
1 Single-mode Fiber, LC duplex
Multi-mode Fiber, LC duplex
Interface Specifications ▀
Notes
—
—
—
1
—
—
2
1
3
4
5
—
—
ASR 5000 Installation Guide ▄
263