Channelized Line Card Interfaces - Cisco ASR 5000 Series Installation Manual

▀ Channelized Line Card Interfaces

Channelized Line Card Interfaces
The CLC2 card supports two types of Small Form-factor Pluggable (SFP) transceiver modules. The type of optical fiber
interface on the line card is dictated by the SFP modules installed on the card. The SFP modules are hot-pluggable.
Table 45. SFP Modules Supported by the CLC2
Module Type Card Identification
Single-mode Channelized (STM-1/OC-3)
Optical Fiber SM IR-1
Multi-mode Channelized (STM-1/OC-3)
Optical Fiber Multi-Mode
Important:
use with the CLC2.
Important:
for Class 1 laser devices for IEC825, EN60825, and 21CFR1040 specifications.
The following figure shows the LC-connectors for the CLC2. Each SFP fiber interface provides both transmit (TX) and
receive (RX) on the port.
▄ ASR 5000 Installation Guide
142
Interface Type
Single-mode Fiber, LC
duplex female connector
Multi-mode Fiber, LC
duplex female connector
The SFP interface is only certified to work with SFP transceiver modules purchased from Cisco for
Because of the optical SFP interface, this product has been tested and found to comply with the limits
Cabling the Channelized Line Cards
Cable Specifications
Fiber Types: Single-mode optical fiber
Wavelength: 1310 nm
Core Size: 9 micrometers
Cladding Diameter: 125 micrometers
Range: Intermediate/21 kilometers
Attenuation: 0.25 dB/KM
Min/Max Tx Power: -15 dBm/-8 dBm
Rx Sensitivity: -28 dBm
Fiber Types: Multi-mode optical fiber
Wavelength: 1310 nm
Core Size: 62.5 micrometers
Cladding Diameter: 125 micrometers
Range: Short/2 kilometers
Min/Max Tx Power: -19 dBm/-14 dBm
Rx Sensitivity: -30 dBm