Cisco ASR 5000 Series Installation Manual page 255

Replacing Line Cards
Step 4
Slide the interlock switch on the front panel of the line card upward to lock the ejector tab in place. The flange on the
left-side of the interlock switch prevents movement of the ejector tab when raised completely.
Important:
rail.
Step 5
Use a Phillips #2 screwdriver to tighten the screws at the top and bottom of the line card's front panel to secure the card
to the chassis.
Step 6 Refer to the destination label on each cable and re-attach the cables to the line card. Refer to the following table to
locate the chapter of this guide that provides information and instructions on cabling the line card.
Line Card
Switch Processor Input/Output (SPIO)
Fast Ethernet Line Card (FLC2)
Gigabit Ethernet Line Card (GLC2)
Quad Gigabit Ethernet Line Card (QGLC)
10 Gigabit Ethernet Line Card (XGLC)
Optical (ATM) Line Card [OLC2]
Channelized Line Card (CLC2)
You must slide the interlock switch upward before securing the card's top screw to the mounting
Chapter
Cabling the Switch Processor Input/Output Line Card
Cabling the Ethernet 10/100 Line Card
Cabling the Gigabit Ethernet Line Cards
Cabling the Optical (ATM) Line Card
Cabling the Channelized Line Card
Installing the Line Card ▀
ASR 5000 Installation Guide ▄
255