Cisco SCE 8000 Installation And Configuration Manual page 230

Informational Messages, Severity Level 6
Error Message %LOCAL7-6-CHANGE_MODE_AUTO: "Management Failover mode has been changed
to automatic mode."
Explanation
mode.
Recommended Action
Error Message %LOCAL7-6-CHANGE_MODE_MANUAL: "Management Failover mode has been
changed to manual mode."
Explanation
mode.
Recommended Action
Error Message %LOCAL7-6-SIMBA_USR_HW_MONITOR_OK: "<%s>
Explanation
the error state or warning state to the normal state.
Recommended Action
Error Message %LOCAL7-6-SIMBA_USR_ALL_HW_MONITORS_OK: "All hardware monitors report
status OK"
Explanation
monitored by the sanity check change from the error state or warning state to the normal state.
Recommended Action
Error Message %LOCAL7-6-PROBLEM_IS_OK: "<%s>"
Explanation
is displayed to indicate that the operational status mentioned in the description is not severe.
Recommended Action
Error Message %LOCAL7-6-EXECUTING_CONFIG_FILES: "Beginning execution of
configuration files."
Explanation
configuration, and party database configuration files begins.
Recommended Action
Cisco SCE8000 GBE Installation and Configuration Guide
C-34
This message is generated when the management failover mode is changed to automatic
None.
This message is generated when the management failover mode is changed to manual
None.
This message is displayed when any of the hardware component statuses change from
None.
This message is generated when the status of all the hardware components that are
None.
The system operational status indicates the current status of the system. This message
None.
This message is displayed when the execution of the startup configuration, application
None.
Appendix C Cisco Service Control Engine System Log Messages