Cisco SCE 8000 Installation And Configuration Manual page 211

Appendix C Cisco Service Control Engine System Log Messages
Error Message %LOCAL7-6-PEER_IP_CHANGED:"IP address of peer box was changed (was
old-ip-addr, changed to new-ip-addr)."
Explanation
changed. The message appears when the existing IP address and the new IP addresses are not
matched in the peer Cisco SCE box.
In this message, old-ip-addr indicates either the old IP address or the existing IP address of the peer
box, and new-ip-addr indicates the new IP address.
Recommended Action
Error Message %LOCAL7-6-PEER_IP_SET:"Peer box IP address is ip-addr."
Explanation
first time. It verifies if the previous IP address is set; if not, the IP address is set to a new IP address.
–
Recommended Action
Error Message %LOCAL7-6-SET_DEFGW:"IP Default gateway set to def-gw-ip-addr.
Explanation
Recommended Action
Error Message %LOCAL7-6-FINISHED_VERIFY: "Package verification finished"
Explanation
is completed successfully.
Recommended Action
Error Message %LOCAL7-6-STARTED_EXTRACT:"Package extraction started on file
'pkg-filename'"
Explanation
Extraction can occur with or without the verification of a package. This message returns the name
of the file on which extraction is initiated.
–
Recommended Action
Error Message %LOCAL7-6-FINISHED_EXTRACT: "Package extraction finished"
Explanation
completed (with or without verification). The filename is displayed after the extraction is completed.
Recommended Action
This message is displayed while the existing IP address of the peer box is being
None.
This message is displayed when Cisco SCE sets the IP address of the peer box for the
In this message, ip-addr is the new IP address set for the peer box.
None.
This message is displayed while a new default gateway for a particular slot is being set.
None.
This debug-related information message is displayed when the verification of a package
None.
This debug-related information message is displayed when package extraction begins.
In this message, pkg-filename indicates the name of the package file.
None.
This debug informational message is displayed when the package extraction process is
None.
Informational Messages, Severity Level 6
Cisco SCE8000 GBE Installation and Configuration Guide
C-15