Rebooting And Shutting Down The Sce Platform; Rebooting The Sce Platform; Examples For Rebooting The Sce Platform; How To Shut Down The Sce Platform - Cisco SCE 8000 Installation And Configuration Manual

10 gbe
Hide thumbs Also See for SCE 8000:
Table of Contents

Advertisement

Rebooting and Shutting Down the SCE Platform

Rebooting and Shutting Down the SCE Platform
This section describes the following topics:

Rebooting the SCE Platform

Rebooting the SCE platform is required after installing a new package, in order for that package to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
When the SCE restarts, it loads the startup configuration, so all changes made in the running
Note
configuration are lost. Save the running configuration before performing reload, as described in
or Changing the Configuration Settings, page
At the SCE8000# prompt, enter reload and press Enter.
Step 1
A confirmation message appears.
Enter y to confirm the reboot request and press Enter.
Step 2

Examples for Rebooting the SCE Platform

The following example shows the commands for system reboot:
SCE8000# reload
Are you sure? y
the system is about to reboot, this will end your CLI session

How to Shut Down the SCE Platform

Shutting down the SCE platform is required before turning the power off. This helps to ensure that
non-volatile memory devices in the SCE platform are properly flushed in an orderly manner.
When the SCE platform restarts, it loads the startup configuration, so all changes made in the running
Note
configuration are lost. Save the running configuration before performing reload, as described in
or Changing the Configuration Settings, page
Connect to the serial console port (The CON connector on the front panel of the Service Control module
Step 1
in slot 1, 9600 baud).
The SCE8000# prompt appears.
Enter reload shutdown.
Step 2
A confirmation message appears.
Cisco SCE8000 GBE Installation and Configuration Guide
7-20
Rebooting the SCE Platform, page 7-20
How to Shut Down the SCE Platform, page 7-20
Chapter 7 Basic Cisco SCE 8000 Platform Operations
7-8.
7-8.
Saving
Saving

Advertisement

Table of Contents
loading

Table of Contents