Error Messages, Severity Level 3; Common Error Messages - Cisco SCE 8000 Installation And Configuration Manual

Error Messages, Severity Level 3

Fatal Message SIMBA_USR_HW_MONITOR_FATAL "<%s>: <%s> hardware monitor status is
FATAL
Error Messages, Severity Level 3

Common Error Messages

Common Error Message %LOCAL7-3-SE_USER_ERROR "SE %s Module: An Error occurred. Please
report to Cisco's customer support"
Common Error Message %LOCAL7-3-"NOT_ENOUGH_MEMORY "Partition init - not enough
memory. Required = %lu + %lu for sys heap, Available = %lu\n Memory will be
adjusted"
Common Error Message %LOCAL7-3-FAILED_TO_ALLOCATE_MEMORY "Part init - failed to
allocate the parent block. size = %lu"
Cisco SCE8000 GBE Installation and Configuration Guide
C-4
Explanation This message is displayed when a fatal error occurs in any of the corresponding
hardware modules.
None.
Recommended Action
Explanation This error message is generated when one of the following scenarios occur:
The hardware monitor sanity check fails.
–
When there is an error in a partition, the ControlCard watchdog timeout handler, and so on.
–
Generate the support file and contact Cisco Customer Support.
Recommended Action
This message is displayed when there is insufficient memory for allocating a new parent
Explanation
block from the VxWorks heap.
None.
Recommended Action
This message is displayed when there is a failure to allocate memory for the parent
Explanation
block, and the log displays the parent block size.
Recommended Action None.
Appendix C Cisco Service Control Engine System Log Messages