Cisco SCE 8000 Installation And Configuration Manual page 217

Appendix C Cisco Service Control Engine System Log Messages
Error Message %LOCAL7-6-SET_MAX_TIRS: "Setting maximum number of TIRs to: %u."
Explanation
limit of IP range to the Traffic Processor IP Range (TIR).
Recommended Action
Error Message %LOCAL7-6-RESET_MAX_TIRS: "Resetting maximum number of TIRs to
default."
Explanation
mappings, which are assigned to the traffic processor, to their default values.
Recommended Action
Error Message %LOCAL7-6-ADD_TIR: "Adding a TIR - Name
Explanation
for a specific IP or range of IP addresses from external management.
Recommended Action
Error Message %LOCAL7-6-REMOVE_TIR:"Removing a TIR - Name
Explanation
are removed using a command.
Recommended Action
Error Message %LOCAL7-6-REMOVE_MAPPINGS_IN_RANGE: "Removing Subscriber mappings in
IP Range
Explanation
specific IP range are removed through external management.
Recommended Action
Error Message %LOCAL7-6-REPLACE_CFG_OK: "Application replace started on slot %ld,
replace is in progress.\nApplication file
Explanation
the current application configuration without the service being disrupted.
Recommended Action
This message is displayed in response to a command that is issued to set a new upper
None.
This message is displayed in response to a command that is issued to set the IP
None.
This message is displayed when a user tries to add the traffic processor and IP mappings
None.
This message is displayed when the traffic processor and IP mappings for a specific IP
None.
This message is displayed when the traffic processor and IP address mappings for a
None.
This message is displayed when a request is issued from external management to replace
None.
Informational Messages, Severity Level 6
Cisco SCE8000 GBE Installation and Configuration Guide
C-21