Cisco SCE 8000 Installation And Configuration Manual page 222

Informational Messages, Severity Level 6
–
–
–
–
–
Note
Recommended Action
Error Message %LOCAL7-6-OPERATIONAL_STATUS_FAILURE_TRAP: "<%s>"
Explanation
failure state after reboot due to one of the following conditions:
–
–
–
Note
Recommended Action
Error Message %LOCAL7-6-SYSTEM_RESET_BYUSER_TRAP: "<%s>"
Explanation
Recommended Action
Error Message %LOCAL7-6-SYSTEM_RESET_BYFATAL_TRAP: "<%s>"
Explanation
Recommended Action
Error Message %LOCAL7-6-SNMP_COLDSTART_TRAP: "<%s>"
Explanation
Recommended Action
Cisco SCE8000 GBE Installation and Configuration Guide
C-26
Temperature raised above threshold
Voltage not in required range
Fans problem
Power supply problem
Insufficient space on the disk
If the condition that causes the Cisco SCE platform to be in the Warning state is resolved, it
means that when the link is up, the Cisco SCE platform will revert back to the operational state.
None.
This SNMP trap is generated to indicate that the Cisco SCE platform will be in the
Power on test failure
Three abnormal reboots in less than 20 minutes
Platform configured to enter the failure mode consequent to failure-induced reboot, which is
configurable using a CLI command
Depending on the cause of the failure, the management interface and the Cisco SCE platform
configuration may or may not be active or available.
None.
This SNMP trap is generated when the system is reset by a user.
None.
This SNMP trap is generated when the system is reset by a fatal trap.
None.
This SNMP trap is generated when the SNMP agent restarts.
None.
Appendix C Cisco Service Control Engine System Log Messages