How To Cable The 10 Gbe Line Interface Ports - Cisco SCE 8000 Installation And Configuration Manual

Chapter 6 Cabling the Line Ports and Completing the Installation

How to Cable the 10 GBE Line Interface Ports

Take the appropriate fiber optic cable (see
Step 1
and plug it into the appropriate port on the 10 GBE interface on the SPA module in slot #3 of the Cisco
SCE 8000. (See
Make sure to push on the connector until you hear a click, which indicates that the connector is fully
inserted and secured in the receptacle. Always make sure that you insert the connector completely into
the socket.
Figure 6-1
Step 2 Verify that the link LED is green.
If the link LED does not light, try removing the network cable plug and reinserting it firmly into the
module socket.
XFP Module Cabling and Connection Equipment, page
Figure 6-1.)
Cabling the 10 GBE Interface
SC E8 00 0-
SI P
How to Cable the 10 GBE Line Interface Ports
SP A -1 X1
0G E- L- V2
SP A -1 X1
0G E- L- V2
Cisco SCE8000 GBE Installation and Configuration Guide
6-11)
6-13