Cisco 340 Series Configuration Manual page 99

Chapter 2 Configuring Local CLI - CLISH
encryption mode (WPA configuration)
To configure Wi-Fi Protected Access (WPA) authentication and associated encryption for an access
point, use the encryption mode command in the SSID configuration mode.
Syntax Description wpapsk
wpa2psk
wpapskwpa2psk
tkip
aes
tkipaes
pass-phrase phrase
Command Default The default is open access and no encryption.
Command Modes
SSID configuration
Examples
This example shows how to configure combined WPA and WPA2 authentication with combined TKIP
and AES encryption, using the passphrase safE478_Ty33Yep-:
encryption mode wpapskwpa2psk type tkipaes pass-phrase safE478_Ty33Yep-
OL-29491-01
encryption mode {wpapsk | wpa2psk | wpapskwpa2psk} type {tkip | aes | tkipaes}
pass-phrase phrase
Configures WPA with preshared key (PSK) authentication.
Configures WPA2 with PSK authentication.
Configures combined WPA and WPA2 with PSK authentication.
Configures Temporal Key Integrity Protocol (TKIP) encryption.
Configures Advanced Encryption Standard (AES) encryption.
Configures combined TKIP and AES encryption.
Configures a passphrase (password). For phrase, enter at least 8 and a maximum
of 63 alphanumerical characters. Dash (-) and underscore(_) characters are
supported.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
encryption mode (WPA configuration)
2-81