Cisco 340 Series Configuration Manual page 93

Chapter 2 Configuring Local CLI - CLISH
wireless-mode
To configure the 802.11 wireless mode for an access point, use the wireless-mode command in the WiFi
AP interface configuration mode.
Syntax Description 0
1
2
4
6
7
8
9
11
Command Default The default is the 802.11b/g/n mixed mode.
Command Modes WiFi AP interface configuration
Usage Guidelines
802.11b/g mixed mode—Select this mode if you have devices in the network that support 802.11b and
802.11g.
802.11b mode—Select this mode if all the devices in the wireless network only support 802.11b.
802.11a mode for 5GHz only—Select this mode if all the devices in the wireless network only support
802.11a in the 5GHz band.
802.11g mode—Select this mode if all the devices in the wireless network only support 802.11g.
802.11n mode for 2GHz only—Select this mode if all the devices in the wireless network only support
802.11n in the 2GHz band.
802.11b/g/n mixed mode—Select this mode if you have devices in the network that support 802.11b,
802.11g, and 802.11n.
802.11b/g mixed mode—Select this mode if you have devices in the network that support 802.11b and
802.11g.
OL-29491-01
wireless-mode {0 | 1 | 2 | 4 | 6 | 7 | 8 | 9 | 11|}
Configures the 802.11b/g mixed mode.
Configures the 802.11b mode.
Configures the 802.11a mode for 5GHz only.
Configures the 802.11g mode.
Configures the 802.11n mode for 2GHz only.
Configures the 802.11n/g mixed mode.
Configures the 802.11a/n mixed mode for 5GHz only.
Configures the 802.11b/g/n mixed mode.
Configures the 802.11n mode for 5GHz only.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
wireless-mode
2-75