Cisco 340 Series Configuration Manual page 72

bg-protection
bg-protection
To configure CTS-to-self protection for an access point, use the bg-protection command in the WiFi AP
interface configuration mode.
Note This command applies to the 802.11b/g mixed mode, 802.11n/g mixed mode, and 802.11b/g/n mixed
mode.
Syntax Description auto
on
off
Command Default The default is automatic selection of CTS-to-self protection.
Command Modes WiFi AP interface configuration
Usage Guidelines CTS-to-self protection minimizes collisions among clients in a mixed mode environment, but reduces
throughput performance.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-54
bg-protection {auto | on | off}
Configures automatic selection of CTS-to-self protection.
Enables CTS-to-self protection.
Disables CTS-to-self protection.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01