Cisco 340 Series Configuration Manual page 71

Chapter 2 Configuring Local CLI - CLISH
beacon-interval
To configure the beacon interval for an access point, use the beacon-interval command in the WiFi AP
interface configuration mode.
Syntax Description interval
Command Default
The default period is 100 milliseconds.
Command Modes
WiFi AP interface configuration
Usage Guidelines The default setting should work well for most networks.
Configure a long interval to:
•
•
•
Configure a short interval to:
•
•
•
OL-29491-01
beacon-interval interval
Period that you want to configure the beacon interval with. The range is
between 20 and 1000 milliseconds. The default is 100 milliseconds.
Increase an access point's throughput performance.
Decrease the discovery time for clients and decrease the roaming efficiency.
Decrease the power consumption of clients.
Minimize the discovery time for clients and improve the roaming efficiency
Decrease an access point's throughput performance.
Increase the power consumption of clients.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
beacon-interval
2-53