Cisco 340 Series Configuration Manual page 82

multicast-mcs
multicast-mcs
To configure the high throughput Modulation and Coding Scheme (MCS) rate on multicast frames when
an access point functions in the 802.11n mode, use the multicast-mcs command in the WiFi AP interface
configuration mode.
This command applies to the 802.11n mode or the 802.11n mixed mode.
Note
Syntax Description index_number
Command Default
The default is 2.
Usage Guidelines
This table shows the MCS index numbers with their potential data rates in Mbps based on MCS, guard
interval, and channel width.
Guard Interval of 800 ns
Index
Number 20-MHz Channel Width 40-MHz Channel Width 20-MHz Channel Width
0 6.5
1 13
2 19.5
3 26
4 39
5 52
6 58.5
7 65
8 13
9 26
10 39
11 52
12 78
13 104
14 117
15 130
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-64
multicast-mcs index_number
The range is from 0 to 15.
13.5
27
40.5
54
81
109
121.5
135
27
54
81
108
162
216
243
270
Guard Interval of 400 ns
40-MHz Channel Width
7 2/9 15
14 4/9 30
21 2/3 45
28 8/9 60
43 1/3 90
57 5/9 120
65 135
72 2/9 152.5
14 4/9 30
28 8/9 60
43 1/3 90
57 7/9 120
86 2/3 180
115 5/9 240
130 270
144 4/9 300
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01