Cisco 340 Series Configuration Manual page 90

transmit burst
transmit burst
To configure the transmit burst (Tx burst) for an access point, use the transmit burst command in the
WiFi AP interface configuration mode.
Syntax Description on
off
Command Default Tx burst is enabled.
Command Modes WiFi AP interface configuration
Usage Guidelines Leave Tx burst on for better throughput performance.
Disable Tx burst if you notice wireless interference in the network.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-72
transmit burst {on | off}
Enables Tx burst.
Disables Tx burst.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01