Cisco 340 Series Configuration Manual page 84

operating-mode
operating-mode
To configure greenfield mode or the mixed mode when an access point functions in the 802.11n mode,
use the operating-mode command in the WiFi AP interface configuration mode.
Note This command applies to the 802.11n mode.
Syntax Description greenfield
mixed
Command Default The default is mixed.
Command Modes
WiFi AP interface configuration
Usage Guidelines Use the greenfield mode if there are only 802.11n clients in the coverage area. If you use the greenfield
mode when 802.11b, 802.11g, and 802.11n clients coexist in the same coverage area, packet collisions
might occur.
Use the mixed mode when 802.11b, 802.11g, and 802.11n clients coexist in the same coverage area.
Cisco Edge 340 Series Software Configuration Guide, Release 1.0
2-66
operating-mode {greenfield | mixed}
Configures the greenfield mode, which improves 802.11n throughput
performance, but prevents 802.11b and 802.11g clients present in the coverage
area from recognizing the 802.11n traffic.
Configures the mixed mode, which allows the 802.11b and 802.11g clients in
the coverage area to recognize the 802.11n traffic. This is the default.
Chapter 2 Configuring Local CLI - CLISH
OL-29491-01